iMX6 Rex 5V power supply modifications
Jump to navigation
Jump to search
This procedure shows how to modify iMX6 Rex Development kit to support 5V power supply.
iMX6 Rex Base Board
| 100px | Note: It is required that the power management unit ISL6236AIRZ is fitted on position U22 |
Top side modifications
Bottom side modifications
Important: It is recommended to test the base board without the module first:
- Set up and double check the input voltage + VIN to 5 Volts.
- Measure other voltage rails if they are set as described in the schematic
- The upper green POK LED diode in position D18 should be on (all sources are turned on the iMX6 Rex Base Board)
| 200px | Note: To power the board, ATX connector (position J38) usage is recommended |
iMX6 Rex Module
| 100px | Note: It is required that the power management unit ISL6236AIRZ is fitted on positions U11 and U13 |
Bottom side modifications
