iMX6 Rex Connecting the Components and Cables

From Voipac Wiki
Revision as of 21:45, 24 October 2021 by Voipac (talk | contribs)
Jump to navigation Jump to search

This page is intended to show the necessary connections and steps to successfully boot and operate the development kit.

Connecting the board

Prepare iMX6 Base Board and plug in (bootable) microSD card, serial cable, Ethernet cable, HDMI cable and other devices or interfaces you need. Plug the power supply connector in. 600px

Default booting selection

To boot from SPI Flash, make sure that BOOT_MODE jumper is not present:
400px

For loading filesystem, micro SD card needs to be plugged into the bottom slot J29:
400px

Retrieved from "https://wiki.voipac.com/index.php?title=iMX6_Rex_Connecting_the_Components_and_Cables&oldid=3097"