Difference between revisions of "iMX6 Rex 5V power supply modifications"
Jump to navigation
Jump to search
| Line 20: | Line 20: | ||
* Measure the input voltage + VIN is set to 5 Volts. | * Measure the input voltage + VIN is set to 5 Volts. | ||
* Other voltage rails voltages are set as described in the schematic | * Other voltage rails voltages are set as described in the schematic | ||
| − | * Check if | + | * Check if the upper green POK LED diode in position D18 is on (all sources are turned on the iMX6 Rex Base Board) |
<br /><br /> | <br /><br /> | ||
Revision as of 08:07, 22 March 2021
This procedure shows how to modify iMX6 Rex Development kit to support 5V power supply.
iMX6 Rex Base Board
| 100px | Note: It is required that the power management unit ISL6236AIRZ is fitted on position U22 |
Top side modifications
Bottom side modifications
Important: It is recommended to test the base board without the module first:
- Measure the input voltage + VIN is set to 5 Volts.
- Other voltage rails voltages are set as described in the schematic
- Check if the upper green POK LED diode in position D18 is on (all sources are turned on the iMX6 Rex Base Board)
| 200px | Note: To power the board, ATX connector (position J38) usage is recommended |
iMX6 Rex Module
| 100px | Note: It is required that the power management unit ISL6236AIRZ is fitted on positions U11 and U13 |
Bottom side modifications
