Difference between revisions of "iMX6 Rex Connecting the Components and Cables"
Jump to navigation
Jump to search
| Line 9: | Line 9: | ||
[[image:iMX6_Rex_Development_kit-Boot_mode_selection.jpg|400px]] | [[image:iMX6_Rex_Development_kit-Boot_mode_selection.jpg|400px]] | ||
| − | + | For loading filesystem, micro SD card needs to be plugged into the bottom slot J29:<br /> | |
[[image:iMX6_Rex_Development_kit-Bottom_SD_slot.jpg|400px]] | [[image:iMX6_Rex_Development_kit-Bottom_SD_slot.jpg|400px]] | ||
Revision as of 20:42, 16 March 2021
This page is intended to show the necessary connections and steps to successfully boot and operate the development kit.
Connecting the board
Prepare iMX6 Base Board and plug in (bootable) microSD card, serial cable, Ethernet cable, HDMI cable and other devices or interfaces you need. Plug the power supply connector in. 600px
Default booting selection
To boot from SPI Flash, make sure that BOOT_MODE jumper is not present:
400px
For loading filesystem, micro SD card needs to be plugged into the bottom slot J29:
400px
