Difference between revisions of "iMX6 Rex 5V power supply modifications"
Jump to navigation
Jump to search
| Line 6: | Line 6: | ||
== iMX6 Rex Base Board == | == iMX6 Rex Base Board == | ||
| − | + | '''''Note:''''' It is required that the power management unit ISL6236AIRZ is fitted on position U22<br /> | |
| − | '''''Note:''''' It is required that the power management unit ISL6236AIRZ is fitted on position U22 | + | [[image:iMX6_Rex_Development_kit-PMIC.jpg|100px]] |
=== Top side modifications === | === Top side modifications === | ||
| Line 20: | Line 20: | ||
* Check if an upper green POK LED light on position D18 is on (all sources are turned on the iMX6 Rex Base Board) | * Check if an upper green POK LED light on position D18 is on (all sources are turned on the iMX6 Rex Base Board) | ||
| − | + | <br />To power the board, ATX connector (position J38) usage is recommended: | |
| − | To power the board, ATX connector (position J38) usage is recommended | + | [[image:iMX6_Rex_Development_kit-ATX_connector.jpg|200px]] |
== iMX6 Rex Module == | == iMX6 Rex Module == | ||
| − | + | '''''Note:''''' It is required that the power management unit ISL6236AIRZ is fitted on positions U11 and U13<br /> | |
| − | '''''Note:''''' It is required that the power management unit ISL6236AIRZ is fitted on positions U11 and U13 | + | [[image:iMX6_Rex_Development_kit-PMIC.jpg|100px]] |
=== Bottom side modifications === | === Bottom side modifications === | ||
[[image:iMX6_Rex_Module-5V_modification_bottom.jpg|800px]] | [[image:iMX6_Rex_Module-5V_modification_bottom.jpg|800px]] | ||
Revision as of 07:51, 22 March 2021
This procedure shows how to modify iMX6 Rex Development kit to support 5V power supply.
iMX6 Rex Base Board
Note: It is required that the power management unit ISL6236AIRZ is fitted on position U22
100px
Top side modifications
Bottom side modifications
Important: It is recommended to test the base board without the module first:
- Measure the input voltage + VIN is set to 5 Volts.
- Other voltage rails voltages are set as described in the schematic
- Check if an upper green POK LED light on position D18 is on (all sources are turned on the iMX6 Rex Base Board)
To power the board, ATX connector (position J38) usage is recommended:
200px
iMX6 Rex Module
Note: It is required that the power management unit ISL6236AIRZ is fitted on positions U11 and U13
100px
Bottom side modifications
