Difference between revisions of "iMX6 Rex 5V power supply modifications"
Jump to navigation
Jump to search
| Line 18: | Line 18: | ||
'''''Important:''''' It is recommended to test the base board without the module first: | '''''Important:''''' It is recommended to test the base board without the module first: | ||
| − | * | + | * Set up and double check the input voltage + VIN to 5 Volts. |
| − | * | + | * Measure other voltage rails if they are set as described in the schematic |
| − | * | + | * The upper green POK LED diode in position D18 should be on (all sources are turned on the iMX6 Rex Base Board) |
<br /><br /> | <br /><br /> | ||
Revision as of 13:49, 23 March 2021
This procedure shows how to modify iMX6 Rex Development kit to support 5V power supply.
iMX6 Rex Base Board
| 100px | Note: It is required that the power management unit ISL6236AIRZ is fitted on position U22 |
Top side modifications
Bottom side modifications
Important: It is recommended to test the base board without the module first:
- Set up and double check the input voltage + VIN to 5 Volts.
- Measure other voltage rails if they are set as described in the schematic
- The upper green POK LED diode in position D18 should be on (all sources are turned on the iMX6 Rex Base Board)
| 200px | Note: To power the board, ATX connector (position J38) usage is recommended |
iMX6 Rex Module
| 100px | Note: It is required that the power management unit ISL6236AIRZ is fitted on positions U11 and U13 |
Bottom side modifications
