Difference between revisions of "iMX6 Rex Memory Calibration"
Jump to navigation
Jump to search
(Created page with "Category:iMX6 Rex Development kit Category:iMX6 Rex Peripherals <!-- --> <div style="float:right">__TOC__</div> == Disclaimer of caution == This procedure is intended...") |
|||
| Line 8: | Line 8: | ||
== Description == | == Description == | ||
| − | Memory calibration procedure consists | + | Memory calibration procedure consists of following steps: |
* Short BOOT_MODE (JP2) jumper on iMX6 TinyRex Base Board | * Short BOOT_MODE (JP2) jumper on iMX6 TinyRex Base Board | ||
* Connect USB_OTG port to host PC utilizing microUSB-USB cable | * Connect USB_OTG port to host PC utilizing microUSB-USB cable | ||
Revision as of 17:09, 21 March 2021
Disclaimer of caution
This procedure is intended for manufacturing use only and should be never applied for shipped iMX6 Rex Modules.
Description
Memory calibration procedure consists of following steps:
- Short BOOT_MODE (JP2) jumper on iMX6 TinyRex Base Board
- Connect USB_OTG port to host PC utilizing microUSB-USB cable
- Power on iMX6 Rex Development kit
- Execute DDR Stress Tester at host PC using command line
- Configure DDR Stress Tester and calibrate memory
- Remove BOOT_MODE jumper
- Power off iMX6 Rex Development kit
Requirements
- micro USB cable
- 12V 1A Power supply
- iMX6 Rex Module and Base Board
- PC controlling the test
- DDR Stress Tester 1.0.3 application
- DDR Stress Tester 2.52 application
Calibration
Stress tester v2.52 (Ultra)
- 4GB RAM - DDR_Stress_Tester_V2.52_Imx6Rex/script/voipac/imx6qp_rex_ultra_MT41K512M16HA-125.inc
