Difference between revisions of "iMX6 TinyRex Ultra Updating SPI Bootloader"
Jump to navigation
Jump to search
(Created page with "Category:iMX6 TinyRex Development kit <!-- --> iMX6 TinyRex Base Board contains SPI Flash memory which can be used for bootloader storage and acts as an alternative to def...") |
|||
| Line 11: | Line 11: | ||
* Serial line terminal | * Serial line terminal | ||
* [http://downloads.voipac.com/index.php?p=iMX6_TinyRex_Development_kit/module/software/uboot/binaries&dl=u-boot-imx6-tinyrexultra-2.3.imx The appropriate file] | * [http://downloads.voipac.com/index.php?p=iMX6_TinyRex_Development_kit/module/software/uboot/binaries&dl=u-boot-imx6-tinyrexultra-2.3.imx The appropriate file] | ||
| − | |||
== Procedure == | == Procedure == | ||
| − | ''''' | + | ''''' Note: ''' In case of module Open MfgTool appropriate BAT file to load bootloader over USB OTG port. Use this step only |
| + | for “VIRGIN” module as described in the above MfgTool Chapter of this document. | ||
Revision as of 09:18, 15 March 2021
iMX6 TinyRex Base Board contains SPI Flash memory which can be used for bootloader storage and acts as an alternative to default SD card firmware location. This guide shows how to flash u-boot and configure it. There is also a possibility to update efuses in an existing module to use SPI memory by default.
Recommended HW:
- PC with USB port
- Voipac iMX6 TinyRex Development kit in Ultra configuration
- USB to Micro-USB cable
Recommended SW:
- Serial line terminal
- The appropriate file
Procedure
Note: In case of module Open MfgTool appropriate BAT file to load bootloader over USB OTG port. Use this step only for “VIRGIN” module as described in the above MfgTool Chapter of this document.