iMX93 Industrial Connecting the Components and Cables

From Voipac Wiki
Revision as of 16:52, 18 February 2025 by Voipac (talk | contribs) (Created page with "Category:iMX93 Industrial Development Kit <!-- --> This page is intended to show the necessary connections and steps to successfully boot and operate the development kit....")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search


This page is intended to show the necessary connections and steps to successfully boot and operate the development kit.

Connecting the board

Prepare iMX Development Baseboard and plug in Micro USB Cable, Ethernet cable and other devices or interfaces you need. Plug the power supply connector in.
iMX93 Components Cables.png

Connecting the Ethernet cable

Connect the Ethernet cable to bottom connector (preset as default) of the Ethernet port.

Components Cables Ethernet.png

Connecting the microSD Card (OPTIONAL)

Insert the micro SD card into the micro SD Slot in case that booting is set from the micro SD card.

NOTE: The Development Kit, which have default setting to boot from SD Card, already contains an inserted SD Card.

Components Cables microSD.png

NOTE: Before Turn On, make sure that S1, S2 and S3 BOOT DIP switches and UART1 and UART2 jumpers are in correct positions in order to boot from the selected storage media (eMMC Flash memory or SD Card). For more details visit iMX93_Industrial_Flashing_Procedure#Running_the_newly_flashed_binaries

Retrieved from "https://wiki.voipac.com/index.php?title=iMX93_Industrial_Connecting_the_Components_and_Cables&oldid=5301"