iMX6 TinyRex Memory Calibration

From Voipac Wiki
Revision as of 21:07, 14 March 2021 by Voipac (talk | contribs) (Created page with "Category:iMX6 TinyRex Development kit Category:iMX6 TinyRex Peripherals <!-- --> <div style="float:right">__TOC__</div> ''''Caution:'''' This procedure is intended fo...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

'Caution:' This procedure is intended for manufacturing use only and should be never applied for shipped iMX6 TinyRex boards.

Description

Memory calibration procedure consists from following steps:

  • Short BOOT_MODE jumper on i.MX6 TinyRex Base board
  • Connect USB_OTG port to host PC utilizing microUSB-USB cable
  • Power on i.MX6 TinyRex Development kit
  • Execute DDR Stress Tester at host PC using command line
  • Configure DDR Stress Tester and calibrate memory
  • Remove BOOT_MODE jumper
  • Power off i.MX6 TinyRex Development kit

Requirements

Retrieved from "https://wiki.voipac.com/index.php?title=iMX6_TinyRex_Memory_Calibration&oldid=448"