i.MX53 SODIMM PC Connecting the Components and Cables

From Voipac Wiki
Revision as of 21:51, 23 October 2021 by Voipac (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

This page is intended to show the necessary connections and steps to successfully boot and operate the development kit.

Connecting the board

Prepare the board by connecting JTAG Cable, Serial line, Ethernet cable and other devices or interfaces if needed.

i.MX25 SODIMM Base Board with i.MX53 Module-Connections.jpg

Important: It is crucial that JTAG 20-pin female connector is plugged in the right way into the header J901. Make sure if the conductor 1 is connected to the Pin 1 before the input power voltage is applied.

Retrieved from "https://wiki.voipac.com/index.php?title=i.MX53_SODIMM_PC_Connecting_the_Components_and_Cables&oldid=2981"