iMX6 TinyRex Basic Updating SPI Bootloader

From Voipac Wiki
Revision as of 16:33, 31 August 2021 by Voipac (talk | contribs)
Jump to navigation Jump to search

iMX6 TinyRex Base Board contains SPI Flash memory which can be used for bootloader storage and act as an alternative to the default SD card firmware location. This guide shows how to flash U-Boot and configure it for SPI memory. An option to update eFuses in an existing module to use SPI memory by default is possible as well.

Recommended HW:

  • PC with USB port
  • Voipac iMX6 TinyRex Development kit in Pro configuration
  • USB to Micro-USB cable
  • Ethernet cable

Recommended SW:

Procedure

Note: In case of booting malfunction, follow USB Booting steps first to load the firmware from PC.

Stop autoboot in serial line terminal. Copy and paste commands separately to download appropriate bootloader file from TFTP server: 

setenv ipaddr 192.168.1.150
setenv serverip 192.168.1.75
mw.b 0x10800000 0xFF 0x80000
tftp 0x10800000 u-boot-imx6-tinyrexbasic-2.3.imx; sf probe 0:0;sf erase
0x0 0x80000;sf write 0x10800000 0x400 0x7fc00

580px

The bootloader is written to Base Board SPI Flash after automatic download from the TFTP Server:
580px

Reset the board. iMX6 TinyRex Module will start booting from SPI Flash. The bootloader will start to download Image from TFTP server by default:
580px

To change bootloader environment, stop autoboot:
580px

Retrieved from "https://wiki.voipac.com/index.php?title=iMX6_TinyRex_Basic_Updating_SPI_Bootloader&oldid=2536"