i.MX51 SODIMM PC Basic Flashing images

From Voipac Wiki
Revision as of 12:43, 13 April 2021 by Voipac (talk | contribs) (Created page with "Category:i.MX51 SODIMM PC - Development kit Category:i.MX51 SODIMM PC Recovery <!-- --> <div style="float:right">__TOC__</div> This section describes flashing Barebox,...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

This section describes flashing Barebox, Linux kernel and filesystem images.

If module could not start loading Barebox from its memory, recover bootloader by following these steps first.

Preparing for files transfer

Make sure FTFP server is up and running. Download the latest images and store them into the TFTP directory:


A local network without DHCP control is recommended. Define network parameters for this network first: 

eth0.ipaddr=192.168.0.150
eth0.netmask=255.255.255.0
eth0.gateway=192.168.0.1
eth0.serverip=192.168.0.75

600px

Erase NAND Flash memory: 

erase /dev/nand0

600px

Downloading and flashing images

Load the firmware files: 

tftp vmx51/barebox-2011_06_0-vmx51-RAM-vpac1.bin /dev/nand0.barebox.bb
tftp vmx51/zImage-2_6_35-vmx51-vpac2.bin /dev/nand0.kernel.bb
tftp vmx51/rootfs-nand-bb-1-18-vmx51-vpac0.ubi.bin /dev/nand0.rootfs.bb

600px

When the process is finished, reset the board. The MAC address was deleted while erasing NAND storage. It is required to be set up again. The MAC address can be found on the sticker placed on the module (in format 00:0d:15:00:XX:XX):
600px

Reset the board. The module boots with newly downloaded files. The default vmx51 login is root without set password: 600px

Retrieved from "https://wiki.voipac.com/index.php?title=i.MX51_SODIMM_PC_Basic_Flashing_images&oldid=1579"