TFT EDT Display Set
Revision as of 20:55, 12 April 2021 by Voipac (talk | contribs) (Voipac moved page TFT Display EDT set to TFT Display EDT Set without leaving a redirect)
This section shows information about TFT EDT Display. This multitouch capacitive display is assigned to be used with the i.MX53, i.MX51 and i.MX25 SODIMM PC - Development kits. It is supported in OS Linux, Android and Qt4e.
The display datasheet can be downloaded from here.
Hardware connection
To make the physical connection between the board and the display easier, TFT EDT display adapter was designed to connect the set together.
To implement the display capabilities, following connections need to be made:
- TFT EDT display adapter is plugged into the Base Board H200 and H700 male headers. By using this two point connection, pin 1 cannot be plugged the wrong way.
- SPI control is established between adapter H2 header and H501 connector on the Base Board using four separate wires (see the picture below)
- A flexible flat cable is plugged for all the connections between the adapter and the display
