i.MX53 SODIMM PC Loading bootloader
Revision as of 08:49, 3 April 2021 by Voipac (talk | contribs) (Voipac moved page i.MX53 SODIMM PC On-Chip Debugging to i.MX53 SODIMM PC JTAG On-Chip Debugging without leaving a redirect)
This page shown the basic setup and instructions how to initiate On-Chip Debugging on i.MX53 SODIMM PC - Development kit. 400px
Windows
JTAG Cable Installation
- Connect JTAG Cable to USB port on the computer. JTAG cable should be automatically recognized and prepared for usage.
- Download OpenOCD v0.6.0 software
- Unzip the files
Running Open On-Chip Debugger
Locate the folder where the software has been unpacked. Run OpenOCD utility in command line (by using Total Commander or Windows Command Prompt):
openocd -f vmx53w.cfg
Download
Download CFG files
wget http://downloads.voipac.com/files/iMX6_Rex_Development_kit/tools/jtag/imx6q-2gb-oocd-0.8.0.cfg
Download BIN files
wget http://downloads.voipac.com/files/iMX6_Rex_Development_kit/tools/jtag/binaries/u-boot-0x27800000_imx6q_20160410.bin
Running OpenOCD
/opt/openocd/bin/openocd -f imx6q-2gb-oocd-0.8.0.cfg
Loading bootloader
Enabling Telnet session on the development kit:
telnet localhost 4444
Running Telnet session:
reset halt load_image /srv/tftp/imx6/u-boot-0x27800000_imx6q_20160410.bin 0x27800000 step 0x27800000 resume