iMX6 OpenRex Memory Calibration
Revision as of 08:56, 27 March 2021 by Voipac (talk | contribs) (Created page with "Category:iMX6 OpenRex SBC Category:iMX6 OpenRex Peripherals <!-- --> <div style="float:right">__TOC__</div> == Disclaimer of caution == This procedure is intended for...")
Disclaimer of caution
This procedure is intended for manufacturing use only and should be never applied for shipped iMX6 OpenRex SBC.
Description
Memory calibration procedure consists of following steps:
- Short BOOT_MODE jumper JP2 on iMX6 OpenRex board
- Connect USB_OTG port to host PC utilizing microUSB-USB cable
- Power on iMX6 OpenRex board
- Execute DDR Stress Tester at host PC using command line
- Configure DDR Stress Tester and calibrate memory
- Remove BOOT_MODE jumper JP2
- Power off iMX6 OpenRex board
Requirements
- micro USB cable
- 5V 2A Power supply
- iMX6 OpenRex SBC
- PC controlling the test
- DDR Stress Tester 2.52 application
Calibration
Stress tester v2.52 (Ultra)
- 4GB RAM - DDR_Stress_Tester_V2.52_Imx6Rex/script/voipac/imx6qp_openrex_ultra_MT41K512M16HA-125A.inc
- 4GB RAM - DDR_Stress_Tester_V2.52_Imx6Rex/script/voipac/imx6q_openrex_max4g_MT41K512M16HA-125A.inc
- 2GB RAM - DDR_Stress_Tester_V2.52_Imx6Rex/script/voipac/imx6q_openrex_max_MT41K256M16TW-107P.inc
- 512MB RAM - DDR_Stress_Tester_V2.52_Imx6Rex/script/voipac/imx6s_openrex_basic_MT41K128M16JT-125K.inc
