iMX6 TinyRex Controlling the Development Kit

This page guides though the first steps of controlling and operating the development kit. To prepare the working setup connect and plug in cables first.

Controlling the Development Kit over Serial Line

Recommended HW:

• PC with USB port
• Voipac iMX6 TinyRex Development Kit
• TTL-232R-3V3 ( FTDI ) cable

Recommended SW:

• Serial line terminal (PUTTY, Minicom, Ckermit, Hyperterminal, TeraTerm, ...)

Default serial port settings:

• Speed (baud): 115200
• Data bits: 8
• Stop bits: 1
• Parity: None
• Flow control: None

Controlling the development kit using TeraTerm:
580px

Using External Monitor and USB Keyboard

Recommended HW:

• External monitor with HDMI connector (HDMI to VGA adapter is required for VGA monitor)
• Voipac iMX6 TinyRex Development Kit
• HDMI High Speed cable
• USB keyboard and USB mouse

Controlling the development kit using external monitor and USB keyboard:
580px

Controlling the Development Kit over Ethernet

Recommended HW:

• PC with Ethernet
• Voipac iMX6 TinyRex Development Kit
• Ethernet cable

Recommended SW:

• Telnet client (Telnet, PUTTY, …)
• SSH client (SSH,PUTTY, …)
• FTP client (FTP, Filezilla, BareFTP, …)
• SFTP client (Filezilla, PUTTY, WinSCP, …)

Important notes:

• iMX6 TinyRex Development Kit is shipped with empty password. The default login is: "root"
• The default IP address is dynamic and setup by your DHCP server upon boot.
• SSH, SFTP services require root password to be set up (“passwd” command)
• FTP, SFTP are recommended only for data transfers (binary mode is recommended)

Controlling the development kit using PUTTY connected to Serial Line:
580px

Controlling the development kit using PUTTY SSH client:
580px

Controlling the development kit using WinSCP:
580px