iMX6 TinyRex Basic Creating Bootable microSD Card

From Voipac Wiki
Revision as of 20:52, 26 October 2021 by Voipac (talk | contribs)
Jump to navigation Jump to search

On this page the recommended procedure for creating a micro SD card contained with the required firmware and software is shown. The following example shows steps used for iMX6 TinyRex Max Module.

Recommended HW:

  • PC with microSD port (or an external SD reader)
  • microSD card

Recommended SW:

Windows

Using USBWriter feature

Some images need to be unpacked first. GZ files can be opened using Total Commander or by installing TAR-GZ file extension.

Open USBWriter. Browse source file (appropriate fsl-image). Select target device:
iMX6 TinyRex Development Kit-USBWriter-Target select.png

Click on Write button and confirm the procedure:
iMX6 TinyRex Development Kit-USBWriter-Confirm.png

iMX6 TinyRex Development Kit-USBWriter-Progress.png

Bootable microSD Card is now created and prepared for use:
iMX6 TinyRex Development Kit-USBWriter-Success.png

Linux

Downloading image

mkdir -pv ~/workdir/imx6/rootfs/yocto
cd ~/workdir/imx6/rootfs/yocto
wget http://downloads.voipac.com/files/iMX6_TinyRex_Development_Kit/module/software/yocto/binaries/fsl-image-gui-imx6-tinyrexbasic-2.3.sdcard.gz

Extracting binary files

gunzip -c fsl-image-gui-imx6-tinyrexbasic-2.3.sdcard.gz | sudo dd of=/dev/mmcblk0 conv=sync bs=64K

or 

sudo dd if=fsl-image-gui-imx6-tinyrexbasic-1.3.sdcard of=/dev/mmcblk0 conv=sync bs=64K
Retrieved from "https://wiki.voipac.com/index.php?title=iMX6_TinyRex_Basic_Creating_Bootable_microSD_Card&oldid=3177"