i.MX51 SODIMM PC Connecting the Components and Cables
Revision as of 20:13, 12 April 2021 by Voipac (talk | contribs) (Created page with "Category:i.MX51 SODIMM PC - Development kit <!-- --> This page is intended to show the necessary connections and steps to successfully boot and operate the development kit...")
This page is intended to show the necessary connections and steps to successfully boot and operate the development kit.
Connecting the board
Prepare the board by connecting JTAG Cable with Serial line, Ethernet cable and other devices or interfaces you need.
800px
Important: It is crucial that JTAG 20-pin female connector is plugged in the right way into the boards Header connector J901. Check if the conductor 1 is connected to the Pin 1 before the input power voltage is applied.