Difference between revisions of "iMX6 TinyRex USB Booting"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
<!-- --> | <!-- --> | ||
| − | These steps guides through loading a bootloader via USB OTG interface. | + | These steps guides through loading a bootloader via USB OTG interface. This can be useful during recovery or bootloader update. |
''''' Recommended HW: ''''' | ''''' Recommended HW: ''''' | ||
| Line 27: | Line 27: | ||
Press Start button (CPU will boot firmware loaded over USB):<br /> | Press Start button (CPU will boot firmware loaded over USB):<br /> | ||
| − | [[image:iMX6_TinyRex_Development_kit-MfgTool_progress.jpg| | + | [[image:iMX6_TinyRex_Development_kit-MfgTool_progress.jpg|400px]]<br /><br /> |
Wait until firmware transfer is finished:<br /> | Wait until firmware transfer is finished:<br /> | ||
| − | [[image:iMX6_TinyRex_Development_kit-MfgTool_finished.jpg| | + | [[image:iMX6_TinyRex_Development_kit-MfgTool_finished.jpg|400px]]<br /><br /> |
The board boots using the firmware loaded over USB:<br /> | The board boots using the firmware loaded over USB:<br /> | ||
[[image:iMX6_TinyRex_Development_kit-Serial_output.jpg|600px]] | [[image:iMX6_TinyRex_Development_kit-Serial_output.jpg|600px]] | ||
Revision as of 13:09, 15 March 2021
These steps guides through loading a bootloader via USB OTG interface. This can be useful during recovery or bootloader update.
Recommended HW:
- PC with USB port
- Voipac iMX6 TinyRex Development Kit
- USB to Micro-USB cable
Recommended SW:
- MfgTool feature
- Serial line terminal
Procedure
Connect USB cable to USB port on your computer and Development Kit USB OTG port.
Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board:
300px
Open an appropriate BAT file:
600px
Execute Manufacturing toolkit at host PC:
600px
Press Start button (CPU will boot firmware loaded over USB):
400px
Wait until firmware transfer is finished:
400px
The board boots using the firmware loaded over USB:
600px
