Difference between revisions of "iMX6 TinyRex USB Booting"
Jump to navigation
Jump to search
| Line 15: | Line 15: | ||
== Procedure == | == Procedure == | ||
| − | Connect USB cable to USB port on your computer and Development Kit USB OTG port.<br /> | + | Connect USB cable to USB port on your computer and Development Kit USB OTG port.<br /><br /> |
Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board:<br /> | Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board:<br /> | ||
| − | [[image:iMX6_TinyRex_Development_kit-Boot_mode_USB.jpg|300px]]<br /> | + | [[image:iMX6_TinyRex_Development_kit-Boot_mode_USB.jpg|300px]]<br /><br /> |
Open an appropriate BAT file:<br /> | Open an appropriate BAT file:<br /> | ||
| − | [[image:iMX6_TinyRex_Development_kit-Boot-file-selection.jpg|600px]]<br /> | + | [[image:iMX6_TinyRex_Development_kit-Boot-file-selection.jpg|600px]]<br /><br /> |
Execute Manufacturing toolkit at host PC:<br /> | Execute Manufacturing toolkit at host PC:<br /> | ||
| − | [[image:iMX6_TinyRex_Development_kit-MfgTool_start.jpg|600px]]<br /> | + | [[image:iMX6_TinyRex_Development_kit-MfgTool_start.jpg|600px]]<br /><br /> |
Press Start button (CPU will boot firmware loaded over USB):<br /> | Press Start button (CPU will boot firmware loaded over USB):<br /> | ||
| − | [[image:iMX6_TinyRex_Development_kit-MfgTool_progress.jpg|600px]]<br /> | + | [[image:iMX6_TinyRex_Development_kit-MfgTool_progress.jpg|600px]]<br /><br /> |
Wait until firmware transfer is finished:<br /> | Wait until firmware transfer is finished:<br /> | ||
| − | [[image:iMX6_TinyRex_Development_kit-MfgTool_finished.jpg|600px]]<br /> | + | [[image:iMX6_TinyRex_Development_kit-MfgTool_finished.jpg|600px]]<br /><br /> |
The board boots using the firmware loaded over USB:<br /> | The board boots using the firmware loaded over USB:<br /> | ||
[[image:iMX6_TinyRex_Development_kit-Serial_output.jpg|600px]] | [[image:iMX6_TinyRex_Development_kit-Serial_output.jpg|600px]] | ||
Revision as of 08:14, 15 March 2021
These steps guides through loading a bootloader via USB OTG interface. It might be useful during recovery or bootloader update.
Recommended HW:
- PC with USB port
- Voipac iMX6 TinyRex Development Kit
- USB to Micro-USB cable
Recommended SW:
- MfgTool feature
- Serial line terminal
Procedure
Connect USB cable to USB port on your computer and Development Kit USB OTG port.
Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board:
300px
Open an appropriate BAT file:
600px
Execute Manufacturing toolkit at host PC:
600px
Press Start button (CPU will boot firmware loaded over USB):
600px
Wait until firmware transfer is finished:
600px
The board boots using the firmware loaded over USB:
600px
