Difference between revisions of "iMX6 Rex USB Booting"
Jump to navigation
Jump to search
| Line 9: | Line 9: | ||
* Voipac iMX6 Rex Development Kit | * Voipac iMX6 Rex Development Kit | ||
* USB to Micro-USB cable | * USB to Micro-USB cable | ||
| − | * | + | * Soldering station |
''''' Recommended SW: ''''' | ''''' Recommended SW: ''''' | ||
Latest revision as of 22:31, 26 October 2021
These steps guide through loading a bootloader via USB OTG interface. This can be useful during recovery or bootloader update.
Recommended HW:
- PC with USB port
- Voipac iMX6 Rex Development Kit
- USB to Micro-USB cable
- Soldering station
Recommended SW:
- MfgTool feature
- Serial line terminal
Procedure
Resolder resistors R0 on position R63 to R62 and R67 to R65 on the base board (Near battery holder J32):
Short BOOT_MODE jumper JP2 on iMX6 Rex Base Board. Connect PC and USB OTG port with a USB cable and power on the base board:
Open an appropriate BAT file:
Execute Manufacturing toolkit at host PC:
Press Start button (CPU will boot firmware loaded over USB):
Wait until firmware transfer is finished:
The board boots using the firmware loaded over USB:
