Difference between revisions of "i.MX51 SODIMM PC Connecting the Components and Cables"
Jump to navigation
Jump to search
(Created page with "Category:i.MX51 SODIMM PC - Development kit <!-- --> This page is intended to show the necessary connections and steps to successfully boot and operate the development kit...") |
|||
| Line 7: | Line 7: | ||
[[image:i.MX25_SODIMM_Base_Board-Connections.jpg|800px]] | [[image:i.MX25_SODIMM_Base_Board-Connections.jpg|800px]] | ||
| − | '''''Important:''''' It is crucial that JTAG 20-pin female connector is plugged in the right way into the | + | '''''Important:''''' It is crucial that JTAG 20-pin female connector is plugged in the right way into the header J901. Make sure if the conductor 1 is connected to the Pin 1 before the input power voltage is applied. |
Revision as of 20:14, 12 April 2021
This page is intended to show the necessary connections and steps to successfully boot and operate the development kit.
Connecting the board
Prepare the board by connecting JTAG Cable with Serial line, Ethernet cable and other devices or interfaces you need.
800px
Important: It is crucial that JTAG 20-pin female connector is plugged in the right way into the header J901. Make sure if the conductor 1 is connected to the Pin 1 before the input power voltage is applied.