Difference between revisions of "i.MX53 SODIMM PC Loading bootloader"
Jump to navigation
Jump to search
m (Voipac moved page i.MX53 SODIMM PC JTAG On-Chip Debugging to i.MX53 SODIMM PC Loading bootloader without leaving a redirect) |
|||
| Line 3: | Line 3: | ||
<!-- --> | <!-- --> | ||
<div style="float:right">__TOC__</div> | <div style="float:right">__TOC__</div> | ||
| − | This page shown the | + | This page shown the steps how to initiate On-Chip Debugging and load bootloader into i.MX53 SODIMM PC - Development kit. |
| − | |||
| − | + | == JTAG Debugger and Programmer Installation == | |
| − | |||
| − | |||
* Connect JTAG Cable to USB port on the computer. JTAG device should be automatically recognized and prepared for usage. | * Connect JTAG Cable to USB port on the computer. JTAG device should be automatically recognized and prepared for usage. | ||
* Download [http://downloads.voipac.com/files/i.MX53_SODIMM_PC-Development_kit/tools/jtag/binaries/openocd-0.6.0-vmx0.zip OpenOCD v0.6.0 software] | * Download [http://downloads.voipac.com/files/i.MX53_SODIMM_PC-Development_kit/tools/jtag/binaries/openocd-0.6.0-vmx0.zip OpenOCD v0.6.0 software] | ||
* Unzip the files | * Unzip the files | ||
| + | [[image:iMX6_Rex_Development_kit-JTAG.jpg|400px]] | ||
| − | + | == Running Open On-Chip Debugger == | |
Locate the folder where the software has been unpacked. Run OpenOCD utility in command line (by using Total Commander or Windows Command Prompt): | Locate the folder where the software has been unpacked. Run OpenOCD utility in command line (by using Total Commander or Windows Command Prompt): | ||
<syntaxhighlight lang="bash"> | <syntaxhighlight lang="bash"> | ||
Revision as of 09:10, 3 April 2021
This page shown the steps how to initiate On-Chip Debugging and load bootloader into i.MX53 SODIMM PC - Development kit.
JTAG Debugger and Programmer Installation
- Connect JTAG Cable to USB port on the computer. JTAG device should be automatically recognized and prepared for usage.
- Download OpenOCD v0.6.0 software
- Unzip the files
Running Open On-Chip Debugger
Locate the folder where the software has been unpacked. Run OpenOCD utility in command line (by using Total Commander or Windows Command Prompt):
openocd -f vmx53w.cfg
Running On-Chip Debugging session:
Download
Download CFG files
wget http://downloads.voipac.com/files/iMX6_Rex_Development_kit/tools/jtag/imx6q-2gb-oocd-0.8.0.cfg
Download BIN files
wget http://downloads.voipac.com/files/iMX6_Rex_Development_kit/tools/jtag/binaries/u-boot-0x27800000_imx6q_20160410.bin
Running OpenOCD
/opt/openocd/bin/openocd -f imx6q-2gb-oocd-0.8.0.cfg
Loading bootloader
Enabling Telnet session on the development kit:
telnet localhost 4444
Running Telnet session:
reset halt load_image /srv/tftp/imx6/u-boot-0x27800000_imx6q_20160410.bin 0x27800000 step 0x27800000 resume