Difference between revisions of "i.MX53 SODIMM PC Connecting the Components and Cables"
Jump to navigation
Jump to search
| Line 7: | Line 7: | ||
[[image:i.MX25_SODIMM_Base_Board-Connections.jpg|800px]] | [[image:i.MX25_SODIMM_Base_Board-Connections.jpg|800px]] | ||
| − | '''''Important:''''' It is crucial that JTAG 20-pin female connector is plugged in the right way into the boards Header connector J901. Check if the conductor 1 is connected to the Pin 1 before the power voltage is applied. | + | '''''Important:''''' It is crucial that JTAG 20-pin female connector is plugged in the right way into the boards Header connector J901. Check if the conductor 1 is connected to the Pin 1 before the input power voltage is applied. |
Revision as of 23:15, 2 April 2021
This page is intended to show the necessary connections and steps to successfully boot and operate the development kit.
Connecting the board
Prepare the board by connecting JTAG Cable with Serial line, Ethernet cable and other devices or interfaces you need.
800px
Important: It is crucial that JTAG 20-pin female connector is plugged in the right way into the boards Header connector J901. Check if the conductor 1 is connected to the Pin 1 before the input power voltage is applied.