Difference between revisions of "iMX6 TinyRex USB Booting"
Jump to navigation
Jump to search
| Line 20: | Line 20: | ||
[[image:iMX6_TinyRex_Development_kit-Boot_mode_USB.jpg|300px]]<br /> | [[image:iMX6_TinyRex_Development_kit-Boot_mode_USB.jpg|300px]]<br /> | ||
| − | * | + | * Open an appropriate BAT file: |
[[image:iMX6_TinyRex_Development_kit-Boot-file-selection.jpg|600px]]<br /> | [[image:iMX6_TinyRex_Development_kit-Boot-file-selection.jpg|600px]]<br /> | ||
| + | |||
| + | * Execute Manufacturing toolkit at host PC: | ||
| + | [[image:iMX6_TinyRex_Development_kit-MfgTool_start.jpg|600px]]<br /> | ||
| + | |||
| + | * Press Start button (CPU will boot firmware loaded over USB): | ||
| + | [[image:iMX6_TinyRex_Development_kit-MfgTool_progress.jpg|600px]]<br /> | ||
| + | |||
| + | * Wait until firmware transfer is finished | ||
| + | [[image:iMX6_TinyRex_Development_kit-MfgTool_finished.jpg|600px]]<br /> | ||
| + | |||
| + | * The board boots using the firmware loaded over USB: | ||
| + | [[image:iMX6_TinyRex_Development_kit-Serial_output.jpg|600px]] | ||
Revision as of 08:11, 15 March 2021
These steps guides through loading a bootloader via USB OTG interface. It might be useful during recovery or bootloader update.
Recommended HW:
- PC with USB port
- Voipac iMX6 TinyRex Development Kit
- USB to Micro-USB cable
Recommended SW:
- MfgTool feature
- Serial line terminal
Procedure
- Connect USB cable to USB port on your computer and Development Kit USB OTG port.
- Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board:
- Open an appropriate BAT file:
- Execute Manufacturing toolkit at host PC:
- Press Start button (CPU will boot firmware loaded over USB):
- Wait until firmware transfer is finished
- The board boots using the firmware loaded over USB:
