Difference between revisions of "iMX8M Industrial Flashing Procedure"

Revision as of 15:39, 23 January 2023

This page describes how to flash binaries into iMX8M Industial Module's eMMC Flash memory or SD card.

git clone ssh://git@github.com/NXPmicro/mfgtools.git
cd mfgtools
mkdir .build && cd .build && cmake .. && make -j`nproc`

The binary called uuu, which is used for flashing, is located in .build/uuu directory.

Go to: https://github.com/NXPmicro/mfgtools/releases
Select the latest stable release.
Example: Releases/uuu_1.4.243: https://github.com/NXPmicro/mfgtools/releases/tag/uuu_1.4.243
Download: uuu.exe
Save the file into: C:\uuu

Set serial downloader mode by sliding DIP switch S1 BOOT positions to: 1-OFF, 2-ON

sudo ./uuu -b emmc_all <path to imx-boot file> <path to wic file>

C:\uuu>uuu.exe -b emmc_all <path to imx-boot file> <path to wic file>

sudo ./uuu -b sd_all <path to imx-boot file> <path to wic file>

C:\uuu>uuu.exe -b sd_all <path to imx-boot file> <path to wic file>

After those steps eMMC or SD card is flashed and perform following steps to boot new image:

unplug USB-C cable from PC
change switch position S1 BOOT to: 1-on, 2-off (boot mode)
be sure that S2 BOOT and S3 BOOT switches are in proper position to boot from desired peripherals (eMMC or SD)
connect debug UART and power on board and messages should appear on serial console

@@ Line 27: / Line 27: @@
 [[File:iMX8M_Industrial_Development_Kit-Serial_donwloader_mode.png|400px]]<br /><br />
-* Plug serial CONSOLE USB Micro B and flashing USB C cables into  the board and the PC
+* Plug USB Micro B cable to CONSOLE connector and USB-C cable to USB-C connector
 * prepare imx-boot and *.wic files
 * run following commands for flashing media