Difference between revisions of "iMX6 TinyRex Pro Creating Bootable microSD Card"
Jump to navigation
Jump to search
| Line 4: | Line 4: | ||
<!-- --> | <!-- --> | ||
<div style="float:right">__TOC__</div> | <div style="float:right">__TOC__</div> | ||
| − | On this page the recommended procedure for creating a micro SD card contained with the required firmware and software is shown. The following example shows steps used for iMX6 TinyRex Pro | + | On this page the recommended procedure for creating a micro SD card contained with the required firmware and software is shown. The following example shows steps used for iMX6 TinyRex Module Pro.<br /><br /> |
''''' Recommended HW: ''''' | ''''' Recommended HW: ''''' | ||
* PC with microSD port (or an external SD reader) | * PC with microSD port (or an external SD reader) | ||
Latest revision as of 20:54, 26 October 2021
On this page the recommended procedure for creating a micro SD card contained with the required firmware and software is shown. The following example shows steps used for iMX6 TinyRex Module Pro.
Recommended HW:
- PC with microSD port (or an external SD reader)
- microSD card
Recommended SW:
Windows
Using USBWriter feature
Some images need to be unpacked first. GZ files can be opened using Total Commander or by installing TAR-GZ file extension.
Open USBWriter. Browse source file (appropriate fsl-image). Select target device:
Click on Write button and confirm the procedure:
Bootable microSD Card is now created and prepared for use:
Linux
Downloading image
mkdir -pv ~/workdir/imx6/rootfs/yocto cd ~/workdir/imx6/rootfs/yocto wget http://downloads.voipac.com/files/iMX6_TinyRex_Development_Kit/module/software/yocto/binaries/fsl-image-gui-imx6-tinyrexpro-2.3.sdcard.gz
Extracting binary files
gunzip -c fsl-image-gui-imx6-tinyrexpro-2.3.sdcard.gz | sudo dd of=/dev/mmcblk0 conv=sync bs=64K
or
sudo dd if=fsl-image-gui-imx6-tinyrexpro-1.3.sdcard of=/dev/mmcblk0 conv=sync bs=64K