Difference between revisions of "iMX6 TinyRex Basic Creating Bootable microSD Card"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| − | [[Category:iMX6 TinyRex Development | + | [[Category:iMX6 TinyRex Development Kit]] |
[[Category:iMX6 TinyRex Basic]] | [[Category:iMX6 TinyRex Basic]] | ||
[[Category:iMX6 TinyRex Recovery]] | [[Category:iMX6 TinyRex Recovery]] | ||
| Line 10: | Line 10: | ||
''''' Recommended SW: ''''' | ''''' Recommended SW: ''''' | ||
| − | * [http://downloads.voipac.com/files/ | + | * [http://downloads.voipac.com/files/iMX6_TinyRex_Development_Kit/tools/USBWriter-1.3.zip USBWriter] |
| − | * [http://downloads.voipac.com/files/ | + | * [http://downloads.voipac.com/files/iMX6_TinyRex_Development_Kit/module/software/yocto/binaries/fsl-image-gui-imx6-tinyrexbasic-2.3.sdcard.gz Appropriate Image file] |
== Windows == | == Windows == | ||
| Line 33: | Line 33: | ||
mkdir -pv ~/workdir/imx6/rootfs/yocto | mkdir -pv ~/workdir/imx6/rootfs/yocto | ||
cd ~/workdir/imx6/rootfs/yocto | cd ~/workdir/imx6/rootfs/yocto | ||
| − | wget http://downloads.voipac.com/files/ | + | wget http://downloads.voipac.com/files/iMX6_TinyRex_Development_Kit/module/software/yocto/binaries/fsl-image-gui-imx6-tinyrexbasic-2.3.sdcard.gz |
</syntaxhighlight> | </syntaxhighlight> | ||
Revision as of 22:20, 23 October 2021
On this page the recommended procedure for creating a micro SD card contained with the required firmware and software is shown here. The following example shows steps used for iMX6 TinyRex Max Module.
Recommended HW:
- PC with microSD port (or an external SD reader)
- microSD card
Recommended SW:
Windows
Using USBWriter feature
Some images need to be unpacked first. GZ files can be opened using Total Commander or by installing TAR-GZ file extension.
Open USBWriter. Browse source file (appropriate fsl-image). Select target device:
400px
Click on Write button and confirm the procedure:
400px
400px
Bootable microSD Card is now created and prepared for use:
400px
Linux
Downloading image
mkdir -pv ~/workdir/imx6/rootfs/yocto cd ~/workdir/imx6/rootfs/yocto wget http://downloads.voipac.com/files/iMX6_TinyRex_Development_Kit/module/software/yocto/binaries/fsl-image-gui-imx6-tinyrexbasic-2.3.sdcard.gz
Extracting binary files
gunzip -c fsl-image-gui-imx6-tinyrexbasic-2.3.sdcard.gz | sudo dd of=/dev/mmcblk0 conv=sync bs=64K
or
sudo dd if=fsl-image-gui-imx6-tinyrexbasic-1.3.sdcard of=/dev/mmcblk0 conv=sync bs=64K