Difference between revisions of "iMX6 Rex UltraPlus Updating SPI Bootloader"
Jump to navigation
Jump to search
| Line 26: | Line 26: | ||
2:2;sf erase 0x0 0x80000;sf write 0x10800000 0x400 0x7fc00 | 2:2;sf erase 0x0 0x80000;sf write 0x10800000 0x400 0x7fc00 | ||
</syntaxhighlight> | </syntaxhighlight> | ||
| − | [[image:iMX6_Rex_Development_kit-SPI_bootloader_write. | + | [[image:iMX6_Rex_Development_kit-SPI_bootloader_write.png|580px]]<br /><br /> |
The bootloader is written to SPI Flash after automatic download from the TFTP Server:<br /> | The bootloader is written to SPI Flash after automatic download from the TFTP Server:<br /> | ||
| − | [[image:iMX6_Rex_Development_kit-SPI_bootloader_written. | + | [[image:iMX6_Rex_Development_kit-SPI_bootloader_written.png|580px]]<br /><br /> |
Reset the board. iMX6 Rex Module will start booting from SPI Flash. The bootloader will start to download Image from TFTP server by default:<br /> | Reset the board. iMX6 Rex Module will start booting from SPI Flash. The bootloader will start to download Image from TFTP server by default:<br /> | ||
| − | [[image:iMX6_Rex_Development_kit-SPI_bootloader_loaded. | + | [[image:iMX6_Rex_Development_kit-SPI_bootloader_loaded.png|580px]]<br /><br /> |
To change bootloader environment, stop autoboot:<br /> | To change bootloader environment, stop autoboot:<br /> | ||
| − | [[image:iMX6_Rex_Development_kit-SPI_bootloader_loaded_stopped. | + | [[image:iMX6_Rex_Development_kit-SPI_bootloader_loaded_stopped.png|580px]] |
Revision as of 17:00, 31 August 2021
iMX6 Rex Module contains SPI Flash memory which is used as a default bootloader storage. This guide shows how to flash U-Boot and configure it for SPI memory.
Recommended HW:
- PC with USB port
- Voipac iMX6 Rex Development kit in UltraPlus configuration
- USB to Micro-USB cable
- Ethernet cable
Recommended SW:
- Serial line terminal
- Appropriate binary file
- TFTP server with the image file stored
Procedure
Note: In case of booting malfunction, follow USB Booting steps first to load the firmware from PC.
Stop autoboot in serial line terminal. Copy and paste commands separately to download appropriate bootloader file from TFTP server:
setenv ipaddr 192.168.1.150 setenv serverip 192.168.1.75 mw.b 0x10800000 0xFF 0x80000 mw.b 0x10800000 0xFF 0x80000;tftp 0x10800000 u-boot-imx6-rexultra-2.4.imx; sf probe 2:2;sf erase 0x0 0x80000;sf write 0x10800000 0x400 0x7fc00
The bootloader is written to SPI Flash after automatic download from the TFTP Server:
580px
Reset the board. iMX6 Rex Module will start booting from SPI Flash. The bootloader will start to download Image from TFTP server by default:
580px
To change bootloader environment, stop autoboot:
580px
