Difference between revisions of "TFT Optrex Display Set"
Jump to navigation
Jump to search
| Line 13: | Line 13: | ||
To implement the display capabilities, following connections need to be made: | To implement the display capabilities, following connections need to be made: | ||
* Optrex TFT display adapter is plugged into the Base Board H200 male header. Make sure pin number 1 is positioned correctly. | * Optrex TFT display adapter is plugged into the Base Board H200 male header. Make sure pin number 1 is positioned correctly. | ||
| − | * A flexible flat cable is used for video connection between the adapter and the display | + | * A flexible flat cable is used for video connection between the adapter CN1 connector and the display |
| − | * Touch screen capabilities are established by additional four signal FFC cable | + | * Touch screen capabilities are established by plugging additional four signal FFC cable into CN2 connector |
[[image:i.MX25_SODIMM_Base_Board-TFT_Optrex_display_adapter-Display_connection.jpg|800px]] | [[image:i.MX25_SODIMM_Base_Board-TFT_Optrex_display_adapter-Display_connection.jpg|800px]] | ||
Revision as of 08:30, 12 April 2021
This section shows information about Optrex TFT display. This display with resistive touch screen is assigned to be used with the i.MX53, i.MX51 and i.MX25 SODIMM PC - Development kits. It is supported in OS Linux, OS Android and OS WinCE 6.0.
The display datasheet can be downloaded from here.
Hardware connection
To make the physical connection between the board and the display easier, Optrex TFT display adapter was designed to connect the set together.
To implement the display capabilities, following connections need to be made:
- Optrex TFT display adapter is plugged into the Base Board H200 male header. Make sure pin number 1 is positioned correctly.
- A flexible flat cable is used for video connection between the adapter CN1 connector and the display
- Touch screen capabilities are established by plugging additional four signal FFC cable into CN2 connector
