iMX6 OpenRex Production

Disclaimer of caution

This procedure is intended for manufacturing and virgin boards only and should be never applied for shipped iMX6 OpenRex SBCs.

BE AWARE THAT E-FUSES PROGRAMMING IS A NON REVERSAL PROCESS! WARRANTY CLAIM CAUSED BY IMPROPER E-FUSES PROGRAMMING WILL NOT BE ACCEPTED!

Information

This procedure will enforce loading firmware from SPI3 port and will set a unique MAC address.

Description

Production procedure consist from following steps:

• Short BOOT_MODE jumper JP2 on iMX6 OpenRex SBC
• Connect UART port to serial terminal (Settings: 115200 8n1)
• Connect USB_OTG port to host PC utilising microUSB-USB cable
• Power on iMX6 iMX6 OpenRex SBC
• Execute Manufacturing toolkit at host PC
• Press Start button (iMX6 OpenRex SBC will boot firmware loaded over USB)
• Wait until firmware (u-boot) is booted (serial terminal)
• Burn eFuses over serial terminal
• Remove BOOT_MODE jumper JP2
• Power off iMX6 OpenRex SBC

Requirements

• microUSB-USB cable
• UART cable
• 5V Power supply
• iMX6 OpenRex SBC
• Windows PC equipped with MfgTool feature and serial line terminal

Configurations

Production-OpenRex-basic.bat  # Production i.mx6s  512MB
Production-OpenRex-max.bat    # Production i.mx6q  2GB
Production-OpenRex-max4g.bat  # Production i.mx6q  4GB
Production-OpenRex-ultra.bat  # Production i.mx6qp 4GB

Procedure

Select appropriate BAT file and start the bootloader transfer over USB OTG interface:
600px

Wait until the process is finished:
600px

The board boots from the loaded firmware:
600px

E-Fuses

This operation is not reversible and should be executed carefully! i.MX6 processor must be replaced in the case of error.

Boot From SPI3

fuse prog 0 5 0x2A000030
fuse prog 0 6 0x00000010

Boot From SATA

fuse prog 0 5 0x00001020
fuse prog 0 6 0x00000010

MAC Address

For example address 00:0D:15:00:D1:75 is used:

fuse prog 4 3 0x000d
fuse prog 4 2 0x1500d175

Testing configuration

To check if E-Fuses were setup correctly, test procedure consist from following steps:

• Ensure that BOOT_MODE jumper JP2 is not present
• Plug micro SD card with valid testing firmware (or plug SATA disk if SATA booting was selected)
• Power on iMX6 OpenRex SBC
• On-board red LED must start flashing automatically (bootloader was executed and kernel loaded)
• Power off iMX6 OpenRex SBC