Difference between revisions of "iMX6 OpenRex Connecting the Components and Cables"
Jump to navigation
Jump to search
(Created page with "Category:iMX6 OpenRex SBC <!-- --> This page is intended to show the necessary connections and steps to successfully boot and operate the development kit. == Connecting th...") |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Category:iMX6 OpenRex SBC]] | [[Category:iMX6 OpenRex SBC]] | ||
<!-- --> | <!-- --> | ||
| − | This page is intended to show the necessary connections and steps to successfully boot and operate the | + | This page is intended to show the necessary connections and steps to successfully boot and operate the single board computer. |
== Connecting the board == | == Connecting the board == | ||
| − | Prepare iMX6 OpenRex SBC and plug in (bootable) microSD card, TTL-232R-3V3 FTDI cable, Ethernet cable, HDMI cable and other devices or interfaces you need. Plug the power supply connector in. | + | Prepare iMX6 OpenRex SBC and plug in (bootable) microSD card, TTL-232R-3V3 FTDI cable, Ethernet cable, HDMI cable and other devices or interfaces you need. Plug the power supply connector in.<br /> |
[[image:iMX6_OpenRex_SBC-Connections.jpg|800px]] | [[image:iMX6_OpenRex_SBC-Connections.jpg|800px]] | ||
=== Serial console connection === | === Serial console connection === | ||
Latest revision as of 12:17, 1 April 2021
This page is intended to show the necessary connections and steps to successfully boot and operate the single board computer.
Connecting the board
Prepare iMX6 OpenRex SBC and plug in (bootable) microSD card, TTL-232R-3V3 FTDI cable, Ethernet cable, HDMI cable and other devices or interfaces you need. Plug the power supply connector in.
Serial console connection
iMX6 OpenRex SBC uses USB to serial cable to control it by default.
IMPORTANT! Be careful when connecting TTL-232R FTDI cable to the board. Check if the cable conductor 1 (black wire) is connected to Pin 1 (Header connector J3 – TTL-232R FTDI) on the board.
Default booting selection
To boot from microSD Card, make sure that BOOT_MODE jumper is not present.
