Difference between revisions of "iMX6 OpenRex Ultra Creating Bootable microSD Card"
Jump to navigation
Jump to search
| Line 39: | Line 39: | ||
=== Extracting binary files === | === Extracting binary files === | ||
<syntaxhighlight lang="bash"> | <syntaxhighlight lang="bash"> | ||
| − | gunzip -c fsl-image-gui-imx6- | + | gunzip -c fsl-image-gui-imx6-openrexultra-2.4.sdcard.gz | sudo dd of=/dev/mmcblk0 conv=sync bs=64K |
</syntaxhighlight> | </syntaxhighlight> | ||
Revision as of 08:00, 27 March 2021
The recommended procedure for creating a micro SD card contained with the required firmware and software is shown here. Following example shows steps used for iMX6 OpenRex SBC in Ultra configuration.
Recommended HW:
- PC with microSD port (or an external SD reader)
- microSD card
Recommended SW:
Windows
Using USBWriter feature
Unpack the downloaded package. GZ files can be opened using Total Commander or by installing TAR-GZ file extension.
Open USBWriter. Browse source file (appropriate fsl-image). Select target device:
400px
Click on Write button and confirm the procedure:
400px
400px
Bootable microSD Card is now created and prepared for use:
400px
Linux
Downloading image
mkdir -pv ~/workdir/imx6/rootfs/yocto cd ~/workdir/imx6/rootfs/yocto wget http://downloads.voipac.com/files/iMX6_OpenRex_SBC/software/yocto/binaries/fsl-image-gui-imx6-openrexultra-2.4.sdcard.gz
Extracting binary files
gunzip -c fsl-image-gui-imx6-openrexultra-2.4.sdcard.gz | sudo dd of=/dev/mmcblk0 conv=sync bs=64K