Difference between revisions of "iMX6 TinyRex USB Booting"
Jump to navigation
Jump to search
| Line 15: | Line 15: | ||
== Procedure == | == Procedure == | ||
| − | Connect USB cable to USB port on your computer and Development Kit USB OTG port. <br /><br /> | + | Connect USB cable to USB port on your computer and Development Kit USB OTG port.<br /><br /> |
| − | Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board: | + | Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board:<br /> |
| − | [[image:iMX6_TinyRex_Development_kit-Boot_mode_USB.jpg| | + | [[image:iMX6_TinyRex_Development_kit-Boot_mode_USB.jpg|300px]] |
Revision as of 08:56, 15 March 2021
These steps guides through loading a bootloader via USB OTG interface. It might be useful during recovery or bootloader update.
Recommended HW:
- PC with USB port
- Voipac iMX6 TinyRex Development Kit
- USB to Micro-USB cable
Recommended SW:
- MfgTool feature
- Serial line terminal
Procedure
Connect USB cable to USB port on your computer and Development Kit USB OTG port.
Short BOOT_MODE jumper on iMX6 TinyRex Base Board and power on the board:
300px
