Difference between revisions of "iMX6 OpenRex Max Creating Bootable microSD Card"

Latest revision as of 17:39, 31 August 2021

The recommended procedure for creating a micro SD card contained with the required firmware and software is shown here. The following example shows steps used for iMX6 OpenRex SBC in Max configuration.

Recommended HW:

PC with microSD port (or an external SD reader)
microSD card

Recommended SW:

Windows

Using USBWriter feature

Unpack the downloaded package. GZ files can be opened using Total Commander or by installing TAR-GZ file extension.

Open USBWriter. Browse source file (appropriate fsl-image). Select target device:

Click on Write button and confirm the procedure:

Bootable microSD Card is now created and prepared for use:

Linux

Downloading image

mkdir -pv ~/workdir/imx6/rootfs/yocto
cd ~/workdir/imx6/rootfs/yocto
wget http://downloads.voipac.com/files/iMX6_OpenRex_SBC/software/yocto/binaries/fsl-image-gui-imx6-openrexmax-2.4.sdcard.gz

Extracting binary files

gunzip -c fsl-image-gui-imx6-openrexmax-2.4.sdcard.gz | sudo dd of=/dev/mmcblk0 conv=sync bs=64K

@@ Line 1: / Line 1: @@
 [[Category:iMX6 OpenRex SBC]]
 [[Category:iMX6 OpenRex Max]]
-[[Category:iMX6 OpenRex Getting Started]]
 [[Category:iMX6 OpenRex Recovery]]
 <!-- -->
@@ Line 12: / Line 11: @@
 ''''' Recommended SW: '''''
 * [http://downloads.voipac.com/files/iMX6_OpenRex_SBC/tools/USBWriter-1.3.zip USBWriter]
-* [http://downloads.voipac.com/files/iMX6_OpenRex_SBC/software/yocto/binaries/fsl-image-gui-imx6-openremax-2.4.sdcard.gz Appropriate Image file]
+* [http://downloads.voipac.com/files/iMX6_OpenRex_SBC/software/yocto/binaries/fsl-image-gui-imx6-openrexmax-2.4.sdcard.gz Appropriate Image file]
 == Windows ==
@@ Line 20: / Line 19: @@
 <br /><br />
 Open USBWriter. Browse source file (appropriate fsl-image). Select target device:<br />
-[[image:iMX6_OpenRex_SBC-USBWriter-Target_select.jpg|400px]]
+[[image:iMX6_OpenRex_SBC-USBWriter-Target_select.png|430px]]
 <br /><br />
 Click on Write button and confirm the procedure:<br />
-[[image:iMX6_OpenRex_SBC-USBWriter-Confirm.jpg|400px]]<br /><br />
+[[image:iMX6_OpenRex_SBC-USBWriter-Confirm.png|430px]]<br /><br />
-[[image:iMX6_OpenRex_SBC-USBWriter-Progress.jpg|400px]]
+[[image:iMX6_OpenRex_SBC-USBWriter-Progress.png|430px]]
 <br /><br />
 Bootable microSD Card is now created and prepared for use:<br />
-[[image:iMX6_OpenRex_SBC-USBWriter-Success.jpg|400px]]
+[[image:iMX6_OpenRex_SBC-USBWriter-Success.png|430px]]
 == Linux ==