Difference between revisions of "i.MX53 SODIMM PC Boot device options"
Jump to navigation
Jump to search
| Line 21: | Line 21: | ||
</syntaxhighlight> | </syntaxhighlight> | ||
| − | Dumping factory E-Fuses configuration: | + | Dumping factory E-Fuses configuration before programming: |
<syntaxhighlight lang="bash"> | <syntaxhighlight lang="bash"> | ||
barebox:/ md -b -s /dev/imx_iim_bank0 | barebox:/ md -b -s /dev/imx_iim_bank0 | ||
| Line 28: | Line 28: | ||
</syntaxhighlight> | </syntaxhighlight> | ||
| − | + | Writing E-Fuses: (example set MAC address 00:01:02:03:04:05) | |
<syntaxhighlight lang="bash"> | <syntaxhighlight lang="bash"> | ||
barebox:/ imx_iim0.permanent_write_enable=1 | barebox:/ imx_iim0.permanent_write_enable=1 | ||
Revision as of 10:23, 4 April 2021
Voipac i.MX53 SODIMM PC - Development kit is delivered with E-Fuses set to boot from NAND interface by default.
Modules support multiple booting options:
- NAND Flash
- microSD/MMC
- SPI Flash
- I2C EEPROM
The procedure described below is intended for special purposes when upon costumer request E-Fuses have been left unprogrammed.
BE AWARE THAT E-FUSES PROGRAMMING IS NON REVERSAL PROCESS! WARRANTY CLAIM CAUSED BY IMPROPER E-FUSES PROGRAMMING WILL NOT BE ACCEPTED!
Programming E-Fuses
Before programming E-Fuses, E-Fuse supply gate must be enabled:
barebox:/ md 0x53fd4064+4 53fd4064: 0000fe62 b... barebox:/ mw 0x53fd4064+4 0xfe72
Dumping factory E-Fuses configuration before programming:
barebox:/ md -b -s /dev/imx_iim_bank0 00000000: 10 10 00 00 01 00 00 02 2b 2b 80 00 02 d9 f4 b1 ........++...... 00000010: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
Writing E-Fuses: (example set MAC address 00:01:02:03:04:05)
barebox:/ imx_iim0.permanent_write_enable=1 barebox:/ mw -b -d /dev/imx_iim_bank1 9+6 0x00 0x01 0x02 0x03 0x04 0x05 barebox:/ md -b -s /dev/imx_iim_bank1 00000000: 01 00 00 00 00 00 00 00 00 00 01 02 03 04 05 00 ........++...... 00000010: 00 00 00 00 00 00 00 19 00 00 00 00 00 00 00 00 ................