Difference between revisions of "i.MX53 SODIMM PC Flashing images"
| Line 71: | Line 71: | ||
[[image:i.MX53_SODIMM_PC-Development_Kit-Flashing_filesystem.jpg|600px]]<br /><br /> | [[image:i.MX53_SODIMM_PC-Development_Kit-Flashing_filesystem.jpg|600px]]<br /><br /> | ||
| − | Reset the board | + | Reset the board.The module boots with newly downloaded files. The default vmx53 login is '''root''' without set password: |
[[image:i.MX53_SODIMM_PC-Development_Kit-Running_Linux.jpg|600px]] | [[image:i.MX53_SODIMM_PC-Development_Kit-Running_Linux.jpg|600px]] | ||
Revision as of 15:07, 3 April 2021
This section describes flashing Barebox, Linux kernel and filesystem images.
If module does not start loading Barebox from its memory, recover bootloader by following these steps first.
Flashing bootloader
Enable serial boot mode by placing a link between pins 1 and 2 of H902 (BOOTMODE) header:
Make sure FTFP server is up and running. Download the latest image and store it into the TFTP directory.
A local network without DHCP control is recommended. Define network parameters for this network first:
eth0.ipaddr=192.168.0.150 eth0.netmask=255.255.255.0 eth0.gateway=192.168.0.1 eth0.serverip=192.168.0.77
Erase NAND Flash memory:
erase /dev/nand0
Download bootloader image from TFTP server:
tftp vmx53/barebox.bin /dev/nand0.barebox.bb
Power off the board and disconnect the JTAG cable as it is not needed anymore. Switch the module to the normal boot mode by changing H902 jumper (BOOTMODE) on the base board (short pins 2 and 3 together):
Power on the board. The module boots from the new Barebox stored in its memory:
600px
Flashing Linux kernel
Download the latest kernel image and store into the TFTP directory.
Before loading the image, set the server address and update the bootloader:
eth0.serverip=192.168.0.77 update barebox tftp folder/barebox-2012.09.0-vmx53-vpac2.bin
Restore bootloader environment to the default state and reset the board afterwards:
erase /dev/nand0.bareboxenv
Update Linux image:
update kernel tftp folder/zImage-3.12.13_vmx53_20151129.bin
Flashing filesystem
Download the latest filesystem and store into the TFTP directory.
Update the stored filesystem image:
update rootfs tftp folder/rootfs-ubifs-bb-1-18-vmx53-vpac0.bin
Reset the board.The module boots with newly downloaded files. The default vmx53 login is root without set password: 600px
