Difference between revisions of "i.MX53 SODIMM PC Loading bootloader"

Revision as of 07:53, 3 April 2021

This page shown the basic setup and instructions how to initiate On-Chip Debugging on i.MX53 SODIMM PC - Development kit. 400px

Connect JTAG Cable to USB port on the computer. JTAG device should be automatically recognized and prepared for usage.
Download OpenOCD v0.6.0 software
Unzip the files

Locate the folder where the software has been unpacked. Run OpenOCD utility in command line (by using Total Commander or Windows Command Prompt):

openocd -f vmx53w.cfg

wget http://downloads.voipac.com/files/iMX6_Rex_Development_kit/tools/jtag/imx6q-2gb-oocd-0.8.0.cfg

wget http://downloads.voipac.com/files/iMX6_Rex_Development_kit/tools/jtag/binaries/u-boot-0x27800000_imx6q_20160410.bin

/opt/openocd/bin/openocd -f imx6q-2gb-oocd-0.8.0.cfg

Enabling Telnet session on the development kit:

telnet localhost 4444

Running Telnet session:

reset halt
load_image /srv/tftp/imx6/u-boot-0x27800000_imx6q_20160410.bin 0x27800000
step 0x27800000
resume

@@ Line 9: / Line 9: @@
 === JTAG Cable Installation ===
-* Connect JTAG Cable to USB port on the computer. JTAG cable should be automatically recognized and prepared for usage.
+* Connect JTAG Cable to USB port on the computer. JTAG device should be automatically recognized and prepared for usage.
 * Download [http://downloads.voipac.com/files/i.MX53_SODIMM_PC-Development_kit/tools/jtag/binaries/openocd-0.6.0-vmx0.zip OpenOCD v0.6.0 software]
 * Unzip the files