Difference between revisions of "iMX6 OpenRex USB Booting"
Jump to navigation
Jump to search
(Created page with "Category:iMX6 OpenRex SBC Category:iMX6 OpenRex Recovery <!-- --> These steps guide through loading a bootloader via USB OTG interface. This can be useful during reco...") |
(No difference)
|
Revision as of 09:37, 27 March 2021
These steps guide through loading a bootloader via USB OTG interface. This can be useful during recovery or bootloader update.
Recommended HW:
- PC with USB port
- Voipac iMX6 OpenRex SBC
- USB to Micro-USB cable
Recommended SW:
- MfgTool feature
- Serial line terminal
Procedure
Connect USB cable to USB port on your computer and OpenRex SBC USB OTG port.
Short BOOT_MODE jumper JP2 on OpenRex SBC and power on the board:
Open an appropriate BAT file:
600px
Execute Manufacturing toolkit at host PC:
600px
Press Start button (CPU will boot firmware loaded over USB):
400px
Wait until firmware transfer is finished:
400px
The board boots using the firmware loaded over USB:
600px
